KITACO Super Power Filter (φ35/Elbow 90°) General Purpose Red Anodized 515-0600351

General purpose φ35 elbow 90° Increases intake air volume and contributes to power up. This type is not easily influenced by conditions. It comes with a hood and is highly effective against dirt, dust, and even rain.

Product introduction: This type is not easily affected by conditions. It has a hood and is highly effective against dirt, dust, and rain. Improves intake efficiency and increases power. The dimensions are the length from the top of the filter to the bottom of the rubber pipe when the filter is held vertically. This is an air filter recommended for normal carburetors. Please pay attention to the installation angle. If the cover is installed upside down, water may collect inside the cover during rain and may block air intake. Carburetor setting is required when installing. The intake efficiency will change, so carburetor settings are required. When driving in the rain, moisture may enter the filter and change the carburetor settings. If the filter diameter is a few millimeters smaller than the vehicle's carburetor diameter, it will be a little tight to fit, but you can install it by pushing it in. If a long rear shock is installed, the filter may interfere with the body. ■For exhaust gas regulated models starting from the 2000 model: Since exhaust gas regulated models are lean combustion, the settings may not come out, so it is not recommended to install power filters, etc. ■About F1 cars: Do not install power filters, air funnels, etc. on F1 cars as it will disrupt fuel regulation. However, this does not apply if a device that can adjust the fuel (injection controller Kitaco I-MAP) is installed and settings can be made. Caution (Disclaimer) > Please read 4990852510986


Manufacturer: KITACO
Brand: KITACO
Model name: 515-0600351
Packing size: ‎20.1 x 13.4 x 7.4 cm; 181.44 g
Product model number: ‎515-0600351
Color: ‎Red anodized
Product weight: ‎181 g