Wave Hobby Tool Series HG Air Tank Pot Plastic Model Tool LT-036

A set of an air tank pot that can be attached to an air compressor to store air and a dedicated rack.Body size: Diameter approx. 110mm / Width approx. 215mm / Height approx. 180mm (on regulator: approx. 237mm) Support rack size (width x height x depth) ): Approximately 215 x 71 x 130mm Tank capacity: 0.7L The air tank body is made of reinforced plastic, eliminating the problem of rust that was a problem with conventional steel air tanks, and making it less likely to be damaged or malfunction due to rust *Book The product does not amplify compressor pressure. Even if you combine it with a small compressor like our Compressor 058 or a type of compressor with low pressure, you may not be able to realize the full effect. *Recommended compressor: one equipped with an automatic pressure switch Air tank pot body (with regulator) / Dedicated support rack / Spiral air hose (effective extension: approx. 1mm) / Simple airbrush hanger x 2 (with screws) Target age: 15 years or older Increase number of items displayed

A set of an air tank pot and dedicated rack that can be attached to an air compressor to store air. - A regulator with a pressure gauge and a built-in air filter is set on the air outlet side. - The outlet joint of the regulator can be rotated to allow for easy handling and painting while adjusting the direction of the air hose. *Note: The working pressure of this product is up to 0.4MPa. Please use so that the air pressure released from the compressor does not exceed 0.4MPa. If the compressor is not equipped with an automatic pressure switch or cannot be used in combination with an airbrush with an air valve, you may need to turn the switch on and off yourself during operation. Body size: Diameter approx. 110mm / Width approx. 215mm / Height approx. 180mm (on regulator: approx. 237mm) Support rack size (width x height x depth): Approx. 215 x 71 x 130mm Tank capacity: 0.7L *Reference value maximum usage Pressure: 0.4MPa or less *The working pressure of this product is up to 0.4MPa. Please use so that the air pressure released from the compressor does not exceed 0.4MPa. Air inlet/outlet joint: S thread (1/8 type) *The image is from the time of development and may differ from the actual product.