EDO-STA Animal Warning Horn Ver.2 ES-103

The wind generated by the vehicle emits ultrasonic waves, reducing the risk of collision with animals that jump out onto the road! Tested by Hokkaido University of Science Set of 2 (1 each of penetrating type and non-penetrating type) Material: Plastic Made in Japan

* "Animal Warning Horn Ver.2" is a new model with the same performance as before, but with a slightly lower height and more stability. * Although this product does not guarantee that it will prevent collisions with animals, we have received many feedback that animals have stopped and collisions have been reduced. [Before installation] Before installing the base mount, decide on the installation location with the horn combined with the base mount. (Bumpers, front grilles, etc. are ideal.) Make sure that the installation location is in an area that is exposed to wind pressure and that there are no obstacles in front of it. If you cannot install it horizontally, please note that if you install it at an angle of more than 25 degrees, you may not be able to capture the wind pressure and the ultrasonic waves will be reduced. It is effective to install them from the center of the vehicle to the left and right. (There is no problem with placing the two types of horns on either the left or right side. There are no particular restrictions on the width.) [Installation method] 1. To prevent the base mount from peeling off, be sure to remove dust, dirt, oil, etc. from the installation location. Please. (When installing in winter, the adhesion of bumpers and front grilles may weaken due to cold or freezing, so please warm them with a hair dryer before installing.) *Do not install on areas that protrude from the vehicle. Please. 2. It will need to be removed for maintenance, so please make sure that the horn can be removed from the base mount, and then apply the adhesive tape on the bottom of the base mount to the installation location. *Please install it perpendicular to the direction of travel so that the wind can be taken in efficiently. When attaching to a motorcycle, please install it on the front fender or in a location higher than the fender where it can be directly attached. [Daily Maintenance] Stones, dust, insects, dirt, etc. can reduce the ultrasonic generation of the horn. To maintain the performance of the horn, remove it from the base mount and perform regular maintenance on the horn. *The included "key" is the part to remove the horn from the base mount. It can be removed by inserting the key between the base mount and the horn, so please clean the horn with a toothbrush etc. If a pebble or the like gets stuck and cannot be removed, you can disassemble it by pressing the left and right levers of the horn alternately. ●Be sure to remove the horn when using a car wash. (There is a possibility that it may come off due to the force of a strong brush.) ●The horn/base mount will deteriorate due to temperature, weather, and age, so please check it on a daily basis. ●This product does not cause any harm to animals. Also, please rest assured that pets traveling with you will not be affected.


Manufacturer: ABA
Brand: EDO-STA
Package size: 15.6 x 8.4 x 2 cm; 40 g
Product model number : ‎ES-103
Special notes: ‎Verification tested product
Product weight: ‎40 g